CLK Diffusion Type Cyclone Dust Remover

Besides, it can work under 1000℃ and 500*105 pa situation if it is made of ceramic material or special metal that are heat-resistant, wear-resistant and corrosion resistant.

Cyclone dust collector is usually used as first phase dedusting system, to filtering large size particles (>5μm) then through Bag Type Dust Collector filtering again. So it is very common that cyclone separator and bag dust collector are using at the same time in one plant to reach local emission standard.

The cyclone dust collector is a kind of dedusting device. The mechanism of dust removal is to make the dust air flow rotating. By centrifugal force, the dust particles are separated from the air flow and trapped in the wall, and then the dust particles fall into the ash bucket with the help of gravity. Each component of the cyclone has a certain size ratio, and the change of each ratio can affect the efficiency and pressure loss of the cyclone, among which the diameter of the dust collector, the size of the air intake and the diameter of the exhaust pipe are the main factors. When using, it should be noted that when a certain limit is exceeded, favorable factors can also be turned into unfavorable factors. In addition, some factors are beneficial to improve the efficiency of dust removal, but increase the pressure loss. Therefore, the adjustment of all factors must be taken into account.

Product Categories : Cyclone Dust Collector Series