http://www.hrdustcollector.com
Home > Products > Dust Collector Fittings > Electromagnetic Pulse Valve > YGHB type low voltage control valve

YGHB type low voltage control valve

    Payment Type: L/C
    Incoterm: FOB,CIF
Basic Info

Model No.Customized

Additional Info

Packagingcarton

TransportationOcean,Land

PortXingang China

Payment TypeL/C

IncotermFOB,CIF

Product Description
The Electromagnetic Pulse Valve (also called diaphragm valve) is the compressed air switch of the dust collecting system of the pulse Bag Type Dust Collector. Under the control of the output signal of the pulse injection control instrument, the dust is blown by the filter bag, and the negative force of the dust collector is kept within the set range, so as to ensure the handling capacity and the dust efficiency of the dust collector. The DMF-Z type electromagnetic pulse valve is a right angle valve. The angle between its inlet and outlet is 90 degrees. It is suitable for the installation and connection of the falcons and the spray pipe of the dust collector. The airflow is smooth, which can provide the green gray veins that meet the requirements.
Right angle air solenoid valve
Pulse solenoid valve, electromagnetic pulse valve working principle:
The diaphragm divides the electromagnetic pulse valve into two air chambers in the front and back, and when the compressed air is connected through the throttle hole into the rear room, the pressure of the rear air chamber will be the outlet of the diaphragm valve, and the electromagnetic pulse valve is in the "closed" state. The electric signal of the pulse injection control instrument is disappearing, the armature of the electromagnetic pulse valve is reset, the air chamber is closed, the pressure of the rear air chamber is raised and the film is close to the valve outlet, and the electromagnetic pulse valve is in the "closed" state.
Working conditions:

When the electromagnetic pulse valve is used, the environmental conditions are very important, which is related to the normal and smooth operation of the electromagnetic pulse valve. The environment conditions of the electromagnetic pulse valve:

DF-Y-40SY electromagnetic pulse valve

1, according to the type of power supply, AC and DC solenoid valves are selected respectively. Generally speaking, AC power supply is convenient to use.
2, in corrosive or explosive environments, corrosion resistance should be preferred according to safety requirements.
3, if the environment space is restricted, please use the multi-function solenoid valve, because it eliminates bypass and three manual valves and is convenient for online maintenance.
4, the power supply voltage fluctuations usually AC +%10%.-15%, DC tolerance of about%10, if ultra poor, must take measures to stabilize or put special order requirements.
5, the highest and minimum temperature of the environment should be selected within the allowable range. If there is excess deviation, special orders should be put forward.
6, the power condition of the electromagnetic pulse valve
7, special occasions such as vibration, bump and impact should be selected in the environment, such as marine solenoid valves.

Product Categories : Dust Collector Fittings > Electromagnetic Pulse Valve

Email to this supplier
  • *Subject:
  • *Messages:
    Your message must be between 20-8000 characters
Communicate with Supplier?Supplier
Liuhuabing Mr. Liuhuabing
What can I do for you?
Contact Supplier