For the normal operation of single-machine dust collector, it is very important to pay attention to and repair it. It is very important to find out the doubts of single-machine dust collector in time. Customers must check and repair it when they use it. Only in this way can the single-machine dust collector work normally.
For the convenience of repairing, customers must prepare a ladder, lighting equipment, and prevent some poisonous and harmful gases from entering the system during the operation of single dust collector. When the single dust collector stops working, they should also use air to replace the gases in the system. If they think that harmful gases still exist, they should use the instrument to check. Acknowledging that the rear can operate, but it is not suitable for single operation. Otherwise, if the doubt can not be found in time, it will constitute a big trouble.
When repairing the interior of a single dust collector, it is necessary to select some corrosion-resistant coatings to prevent corrosion. Under normal conditions, because the purified gas is mostly acidic, epoxy resin-based acid-resistant coatings are often used. The gap of the box body is usually padded with rubber, rubber pad, asbestos pad, etc. to prevent gas leakage. With the extension of time, some gaskets will become old, degenerate, damage and fall, which will aggravate the air leakage.
When repairing, it is found that the above phenomena should be taken seriously, replaced or plugged, and air leakage should be prevented as far as possible. Epoxy resin and leak-proof cement are good data in the existing leak-proof materials guess. If the holes are formed by dust erosion, they are repaired and welded.